Raise3D Industrial PA12 CF+ and Raise3D Industrial PA12 CF Support filaments are hydrophilic, meaning they easily absorb moisture in the air after long-term exposure, resulting in jamming or serious wire drawing problems. Here are some notes on drying and storage of PA12CF+ and PA12CF support filament.
1.Before printing, you should dry the filaments in the drying baker at 80℃for 8 hours.
2. In the printing process, the filaments should be placed in the Filament Dry Box.
Note: Raise3D filaments dry box contains silica gel desiccants (100g/pack) to absorb moisture from the air. If you do not often open the dry box, the desiccant can keep the humidity in the dry box below 25% for a month. If the weight of a single packet of desiccant is greater than 110g/ packet, you can put the desiccant into the microwave oven for 3-5 minutes to restore its drying ability. It is recommended to replace the desiccant once a month. Alternatively, put the desiccant into the microwave oven for 3-5 minutes to restore its drying ability.
3.Filament that is not used for a long time can be temporarily stored in the dry box. Before the next use, you should dry the filaments in the drying baker at 80℃for 8 hours.
