[ Manual N2＆N2 Plus - How to Update Heating Plate from 9 Point to 13 Point- V1.0 ]
① Pliers
② 2mm Hex Wrench
③ 5.5mm Hex Wrench
④ Hot Glue Gun
⑤ Socket Wrench
1. Select the Z home button. Once the bed completely homes, select Z value button in “Utilities” page and set the height to 20mm.
2. Turn off the power and unplug the printer. Open the front door and remove the build plate.
3. Carefully unplug the heating bed wires behind the heating bed.
Note: If the wire connectors are covered by glue, remove the glue with tweezers or side cutters.
4. Use a 5.5mm socket wrench to remove the 9 nuts under the Z platform and take out the nine protuberant heating plate.
5. Use pliers to hold the nuts under the screws and use a 2mm hex wrench to remove the screws. Remove the 9 screws on the heating bed with a 2mm hex wrench, holding nuts at the other side of the bed with pliers to take insulation plate and the heating bed apart.
Note: For achieving the best results, it is recommended to ask a second person for help.
6. Use a 2mm hex wrench to remove the four M3 screws on the clamps.
7. Remove the insulation spacer on the plate.
8. Turn the new heating bed to have the back side up.
9. Place the insulating gasket in the center of the heating plate, and use 5 screws to install the new heating plate (with 13 holes) and the old insulating plate at the positions marked below. Then install the two clamps.
10. Align the plate to match the screw holes on the Z platform. Install the five screws to install it on the Z platform.
11. Plug the cables into the new bed.
12. Apply hot glue onto the connectors with the glue gun to secure them.
13. Reinstall the build plate.
14. Lower the Z platform down to a proper position.
15. To confirm whether the bed is leveled, please refer to N2&N2 Series- How to Level the Heating Bed.
[ Manual N2＆N2 Plus - How to Update Heating Bed from 9 Point to 13 Point - V1.0 ]
-END-
