• Extruder connecting board Replacement Guide

[ Manual Pro2 Series - 024 Extruder connecting board Replacement Guide –V1.0 ]

Tools:

①2.5mm wrench

②Flat head screw driver

③Flush cutter


1. Power off the printer.


2. Use a 2.5mm wrench to remove two screws on the Extruder connecting board.


3. Unplug and disconnect all the wires.(If the connector is covered by glue, remove glue with small flat head screwdriver.) 


Shown in the following picture



How to install the heating rod cable and the thermocoupler cable


Heating rod:Insert the heating rod cables with flat head screwdriver. (Note: Make sure the base of the bare wiring isn’t too long as it may cause short circuiting.)

Thermocouple:Insert the thermocouple power supply cable with a flat head screwdriver. (Note: Make sure the base of the bare wiring isn’t too long and cause a short circuit


After all the wires are installed mount the board to the side of the print head

[ Manual Pro2 Series - 024 Extruder connecting board Replacement Guide –V1.0 ]


-END-

Was this article helpful?
Thanks for your feedback.
Thanks for your feedback. help.raise3d.com
Yes
No