[ Manual Pro2 Series - How to Install the Side Cooling Fan Cover - V1.0 ]
Note: The steps for replacing the cooling fans on both sides are similar. Here we use rights as a reference.
1. Unload the filament from both nozzles.
1) Set both extruders to the proper unloading temperature. The recommend target temperature is typically 5-10℃ higher than its common printing temperature.
2) Select “Unload” to begin the unloading process.
3) After the unloading process is completed, remove the filament and the filament guide tube from the extruder.
2. Turn off the printer after the filament is removed.
3. Remove the screws marked in the figure below and take the cooling fan off with the fan duct.
4. Remove the screws marked in the figure below and take the fan duct off.
5. Replace it with a new fan duct.
Note: Make sure that the surface of fan with tags is facing the support.
4. reinstall all the screws.
[ Manual Pro2 Series - How to Install the Side Cooling Fan Cover - V1.0 ]
-END-