[ Manual Pro2 Series - How to Replace the Ground Wire -V1.0 ]
① 3mm hex wrench
② Socket cap screw M3x6
③ File
④ Retractable razor knife
1.Gently lay the printer down on its left side and remove the bottom cover.
Note: With the filament door side up.
2. Use the 3mm wrench to remove the screw at the connection between the ground support tube and aluminum frame, and remove the 2 ground support tubes.
3. Polish the left screw hole at the top of both 2 ground support tubes.
4. Polish the screw holes in the aluminum frame until the aluminum surface is visible.
5. Remove the black insulation tape from the power cord and cut the ground wire. Insert one end of the ground wire into the left side of the polished ground support tube, and install the ground wire with 1 M3*6 Socket cap screw.
6. Install the bottom shell.
[ Manual Pro2 Series - How to Replace the Ground Wire -V1.0 ]
-END-