• Motion Controller Board Replacement

[ Manual Pro2 Series - 033 Motion Controller Board Replacement-V1.0 ]

1. Turn off the printer.


2. Pull the cover out at the top left corner by hand gently and insert a flat head screwdriver to remove the cover.


3. The Motion Controller Board is shown as below.


4. Remove the glue on connectors of cables and terminals on board.


5. The structure of the Motion Controller Board

  • This section is divided into three parts. 
  • Please go through all the wirings on board to get a brief idea from below images first then start unplugging.


6. Right Side Sections


7. Middle Sections


8. Left-side Sections


9. After confirming the wirings Motion Controller Board, please remove the cables one by one carefully.

Then replace the new Motion Controller Board. 


[ Manual Pro2 Series - 033 Motion Controller Board Replacement-V1.0 ]


-END-

Was this article helpful?
Thanks for your feedback.
Thanks for your feedback. help.raise3d.com
Yes
No