[ Manual Pro2 Series - 039 Touchscreen Replacement Guide-V1.0 ]
① 2.5mm hex wrench
② 2mm hex wrench
③ Philips head screw driver
④ Antistatic wrist strap
1. Remove fixing screws from the PC cover with 2.5 mm hex wrench and remove the magnetic bar. The two silver Philips screws must also be removed to get the magnetic bar out.
2. Unplug wires and remove the old screen from the frame by removing the 3 screws on the inside of the front before preparing the new screen. Use a 2mm hex wrench to remove the fixing screws on the back cover of screen box, then open the back cover.
3. Remove the screw with a 2.5mm hex wrench to remove the magnetic bar.
4. Disconnect Ethernet Cable, USB Cable, Camera Cable, Power Cable, Reset button and loosen the screw which attaches the ground line from the old screen. (If your Ethernet cable is connected into the screen, remove screws and the Ethernet cable adapter.)
5. Remove the old touchscreen from the printer by removing the 3 screws on the inside of the front
6. Prepare touchscreen by feeding the cables into the bottom of the touchscreen and putting the screen into the printer. Once all the cables are inside the touchscreen box, attach the Ethernet adapter to the Ethernet cable and plug into Touch Screen. Carefully plug the cables back in. The plugs for the USB and Camera cable are interchangeable. Then secure the ground wire on the touchscreen.
If the structure of your main board is shown below :
7. Disconnect Ethernet Cable, USB Cable, Camera Cable, Power Cable and unscrew the screw which fix the ground line from the old screen.
The order of the pins of the harness: From left to right, the first one starts with the black pin and the second one starts with the red pin.
Re-assemble all of the components following the above steps.
[ Manual Pro2 Series - 039 Touchscreen Replacement Guide-V1.0 ]
-END-