1. Caution! The nozzle temperature is very high.
2. The hot end can only be disassembled with no filament in the extruder. Please select "Unload Filament" on RaiseTouch to unload the filament.
1.The black lines mark the interchangeable hot end. Make sure you do not touch the nozzles when you disassemble the interchangeable hot end, as they are very hot.
2.Open the clamp and rotate it upwards to a 90° angle.
3.Hold the black handle and pull the interchangeable hot end out horizontally.
Note:
1.Make sure the opening angle of the clamp is not too small.
2.When removing, do not pull the hot end upwards.
1. Caution! The nozzle temperature is very high.
2. Please carry out the Z probe offset Calibration whenever the hot end is replaced.
1.Open the clamp and rotate it upwards to a 90° angle.
2.Align the hot end with the groove on the extruder. Insert the hot end horizontally until the pin is aligned with the clamp.
3.Press down the clamp to fasten the handle.
Note:
1.Do not press the clamp without inserting the hot end.
2.If the pin is not aligned with the buckle, you will not be able to fasten the clamp.
3.Make sure the handle is properly fasten by the clamp.
