Per-Model Extruder refers to choosing an extruder for your model. If you have set the Extruder Count to be 2, this interface will show Left Extruder and Right Extruder. If you have set the Extruder Count to be 1, this interface will show Primary Extruder only. The left extruder is defined as primary extruder by default.
Template refers to printing settings. It can apply different templates for different models. But the printing template must be under the same printer and the same filament.
Note: This function is only available if the Sequential Printing function is enabled.
Figure 1: Add other settings into the Per-Layer settings.
-END-
