Tool & Part：
①1.5 mm hex wrench
②The interchangeable hot end handle assembly for replacement
A. Disassemble the Interchangeable Hot End
1.You need to remove the interchangeable hot end from the extruder. Please refer to “How to Install and Disassemble the Interchangeable Hot End” for the steps about how to disassemble the interchangeable hot end.
B. Replace the Interchangeable Hot End Handle Assembly
1.As shown in the red circles in the figure below, find the two screws on the interchangeable hot end handle assembly, unscrew them with the hex wrench, and remove the interchangeable hot end handle assembly from the interchangeable hot end.
2.Install the interchangeable hot end handle assembly for replacement back to the interchangeable hot end, and tighten the two screws that were unscrewed in the above step. The replacement of the interchangeable hot end handle assembly is complete.
[15.116-EN.1.0.20230725-Pro3 Series -How to Replace the Interchangeable Hot End Handle Assembly]
-End-
